Lbl-lighting 2-Circuit MO Direct Feed Standoff for Canopy Manual do Utilizador Página 1

Consulte online ou descarregue Manual do Utilizador para Iluminação Lbl-lighting 2-Circuit MO Direct Feed Standoff for Canopy. LBL Lighting 2-Circuit MO Direct Feed Standoff for Canopy User Manual Manual do Utilizador

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 2
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 0
Installation Instructions for
1.0
HANGERDIRRC-_1-2
980MR2SPPFC
1
GP I :ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product is intended to be used with LBL Direct Power Feed
Canopies and 2-Circuit Monorail system only.
Install the Rigid Standoffs
ANCHOR
Select a location on the ceiling where the 2-Circuit Monorail is
to be mounted.
One way of marking the standoff locations on the ceiling is to
lay the 2-Circuit Monorail on the floor underneath of the
selected location and by using a plumb bob pointing on the
center of the 2-Circuit Monorail, mark the points on the
ceiling.
The other way is to hold the 2-Circuit Monorail directly
against the ceiling and mark the standoff points on the ceiling.
Tap the anchors at the marked points up to the threaded
portion with a hammer.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple.
Repeat step 4 through 6 for the remaining standoffs.
ANCHOR
WASHER
#8 SCREW
THREADED NIPPLE
CAUTION: This standoff is not applicable with
vaulted ceilings.
CEILING
Rigid Standoff for Direct Power Feed Canopies
2-Circuit Monorail
1B
1A
1
2
3
4
6
5
4
6
1B
1A
5
7
1B1C
Vista de página 0
1 2

Resumo do Conteúdo

Página 1 - Install the Rigid Standoffs

Installation Instructions for1.0HANGERDIRRC-_1-2980MR2SPPFC1GP I :ENERAL RODUCT NFORMATIONThis product is suitable for indoor dry locations only.This

Página 2 - SAVETHESE INSTRUCTIONS!

Screw the standoff support post completely to the threadednipple.Repeat this step for the remaining standoffs.SUPPORT POSTTHREADED NIPPLEInstall the 2

Comentários a estes Manuais

Sem comentários